mirror of
https://github.com/NixOS/nixpkgs.git
synced 2024-11-23 23:43:30 +00:00
10f35ff05d
Meson now comes with its own set of commands for building, testing, installing etc., that by default wrap around Ninja. The reason to prefer using the Meson commands is that they take additional options (e.g. setting custom timeouts for tests — my motivation for this change). Here, I've modified the Meson setup hook so that Meson's test and install commands will be used instead of Ninja's when Meson's configurePhase is used. This restriction is to avoid starting to run Meson directly when dealing with custom build systems that wrap around Meson, like QEMU's. We don't use meson's compile command, as it just runs ninja, and that's handled fine by the existing Ninja setup hook. Naturally the Meson commands don't support entirely the same set of options that the Ninja ones did, but I checked through Nixpkgs to find any packages using Meson that used any options that wouldn't be picked up by this new system. I only found one, and it was just setting checkTarget = "test", which is the default value for Ninja and has no Meson equivalent (because we directly tell Meson to run the tests rather than going through a generic job system like Ninja). Link: https://github.com/NixOS/nixpkgs/issues/113829 Co-authored-by: Jan Tojnar <jtojnar@gmail.com>
6 lines
398 B
Markdown
6 lines
398 B
Markdown
# ninja {#ninja}
|
|
|
|
Overrides the build, install, and check phase to run ninja instead of make. You can disable this behavior with the `dontUseNinjaBuild`, `dontUseNinjaInstall`, and `dontUseNinjaCheck`, respectively. Parallel building is enabled by default in Ninja.
|
|
|
|
Note that if the [Meson setup hook](#meson) is also active, Ninja's install and check phases will be disabled in favor of Meson's.
|