nordic-dev.net/nixpkgs
nordic-dev.net/nixpkgs
2
0
Fork 0
mirror of https://github.com/NixOS/nixpkgs.git synced 2024-11-23 15:33:13 +00:00
Code Issues Packages Projects Releases Wiki Activity
151e72cb75
nixpkgs/doc/hooks/ninja.section.md
Alyssa Ross 10f35ff05d meson.setupHook: prefer meson commands over ninja 
Meson now comes with its own set of commands for building, testing,
installing etc., that by default wrap around Ninja.  The reason to
prefer using the Meson commands is that they take additional
options (e.g. setting custom timeouts for tests — my motivation for
this change).

Here, I've modified the Meson setup hook so that Meson's test and
install commands will be used instead of Ninja's when Meson's
configurePhase is used.  This restriction is to avoid starting to run
Meson directly when dealing with custom build systems that wrap around
Meson, like QEMU's.  We don't use meson's compile command, as it just
runs ninja, and that's handled fine by the existing Ninja setup hook.

Naturally the Meson commands don't support entirely the same set of
options that the Ninja ones did, but I checked through Nixpkgs to find
any packages using Meson that used any options that wouldn't be picked
up by this new system.  I only found one, and it was just setting
checkTarget = "test", which is the default value for Ninja and has no
Meson equivalent (because we directly tell Meson to run the tests
rather than going through a generic job system like Ninja).

Link: https://github.com/NixOS/nixpkgs/issues/113829
Co-authored-by: Jan Tojnar <jtojnar@gmail.com>
2023-10-09 10:21:36 +00:00

398 B
Raw Blame History

ninja

Overrides the build, install, and check phase to run ninja instead of make. You can disable this behavior with the dontUseNinjaBuild, dontUseNinjaInstall, and dontUseNinjaCheck, respectively. Parallel building is enabled by default in Ninja.

Note that if the Meson setup hook is also active, Ninja's install and check phases will be disabled in favor of Meson's.